jam123

I have a new amp as well so it's all good the old ones are gone so a new life. One more qestion when sending the signal from my mixer to the amp should the vu levels be just going into the red or not going into the red at all?

I have decided to buy some new speakers, However i was told that new speakers must be "WARMED UP" Is there a specific way to do this or is it just rubbish?

no i believe i am stuffed. I think im gunna have to buy some new ones. Do u have any reccomendations that are fairly cheap. Are intimidations any good for starters?

Ive tryed swapping the leads earlier and I am using the bose controller. I am using an old peavy amp deca 1200 i believe its output is 4 ohms. Only one channel works on the amp so im using both the out puts on that one channel for both speakers. However i had the speakers working perfectly earlier but then when i turned them back on the amp started cutting out and i had the same problems as before, I couldnt play the music loud enough without the amp cutting out. I dont understand how they can be working perfectly one moment not working at all?

I have a pair of bose 802 series 2s. However one of the speakers is not working to its full capacity and will only play music very quietly if it is turned up it becomes very distorted. Does this mean the speaker is blown or is it something to do with the leads/amp set up?